Text Box: All products on this page are compatible with all Aquadyne controllers.

                       

Learn how X10 works.

 

Text Box: Certain devices such as electronic ballasts and large motors can generate sufficient EMI to effect reliable X-10 operation. A simple way to filter out this noise is with the Plug-in Isolator. Simply plug the problem device into the Isolator, then plug the Isolator directly into a control module. Specifications: ·        120 VAC @ 60 Hz ·        5 Amp ·        For USA Use only  

 

 

 

 

                   

 

    `           

 

 

 

 

 

 

 

                           

Text Box: Provides for complete isolation of the Octopus or AquaNode when the operation of multiple controllers is desired on the same circuit. Also useful for eliminating noise problems generated by equipment not directly associated with the application (i.e. televisions, stereo equipment, etc.). Installs directly at circuit breaker. Specifications: ·        120 VAC @ 60 Hz ·        15 Amp ·        For USA Use Only  

                           

 

 

 

 

 

 

 

Text Box: The X-10 2 & 3 Phase Home Isolator keeps extraneous noise and X-10 signals from entering your home. This prevents against signal interference for the X-10 commands issued by the Aquadyne computer. It slips over the neutral wire feed entering your home and has a signal bridge/coupler built-in. Each phase is rated at 200 Amps, and is ideal for apartment buildings, condominiums, attached-unit dwellings and single family homes sharing the same electrical transformer as another home.   SSpecifications: ·        120/240/277VAC @ 60 Hz ·        Up to 200 Amp Service ·        For USA Use Only    

                           

                           

 

 

 

 

 

Text Box: Fluorescent light ballasts often generate an enormous amount of noise. This problem often tends to worsen with age as the ballasts deteriorate, causing problems to arise long after the installation of the X-10 powerline control system. This noise can play havoc with X-10 signals which rely on clean power lines for communication between the Control Interface and the Control Module. X-10 Noise Block wires to the line side of any fixture using an electronic ballast.   Specifications: ·        120 VAC @ 60 Hz ·        5 Amp ·        For USA Use Only